It never fails – you are in a hurry and the children are throwing a tantrum from the backseat. You go to start your car and everything you hear is a clicking noise. Great.
You feel the battery is the problem but you are not sure. Luckily, you can assess the state of charge of your battery utilizing an inexpensive multimeter. This evaluation will show whether your battery is completely charged, and enable you to know how to check your car battery.
Part 1 of 2: Examine the battery
So as to safely and economically test your battery life, you require a few fundamental tools.
Step 1: Locate the battery. The very first step is to find the battery.
Most batteries are under the hood close to the fender. But some producers prefer to conceal the battery in obscure areas. They might be in the back, below the rear seat – and a few are mounted at the wheel well!
If you can not find your battery, then consult your owner’s guide or perform a fast search on your auto model to show the place.
Step 2: Establish your test gear. Switch the vehicle’s ignition and lights away, and have your stuff ready.
You don’t have to fear if you receive the leads backward; you will just observe a negative reading rather than a positive person.
Switch your meter into the DC liter setting. Here is the DC reading together with the line over it. The DC reading together with the squiggly item (sine wave in specialized conditions) is AC voltage. This really isn’t the setting you need, if you don’t intend on analyzing appliances. Thus, save AC for your washing machine.
Step 3: Read the evaluation results.
- 12.66 volts = 100% billed
- 12.45 volts = 75% billed
- 12.24 liter = 50% billed
- 12.06 liter = 25% billed
- 11.89 liter = 0 percent billed
These readings are to get a battery at 80 degrees Fahrenheit. The battery voltage will alter .01 volts for each 10-degree change in temperature.
If your battery is higher than 12.45 volts it’s sufficiently charged. Anything below that ought to be recharged and analyzed with specialist test equipment.
- Notice: A condition of charge test doesn’t indicate if your battery is bad or good. It merely indicates the present condition of charge. A battery which has a very low state of charge might still be good after it’s recharged. A fantastic battery is one which is going to hold a fee. A lousy battery is one which doesn’t.
Should you choose on the second choice, you’ll have to jump your battery. After that, push the car for 20 minutes or so at rates over 40 mph. It is also possible to remove your battery and get it billed in the auto parts shop. Most will carry out this service at no cost.
Measure 6: Totally examine the battery. When the battery is fully charged, it may be analyzed to ascertain whether it’s bad or good. Most auto parts stores will do so at no cost.
There are two approaches for fully testing a battery life:
- If the voltage falls below 9.6 volts through the evaluation, it’s bad and needs to be replaced.
- Having a digital tester: This test sends a frequency wave through the entire battery to ascertain the state of the cells inside.
Articles Source: https://www.yourmechanic.com/article/how-to-check-a-car-battery